2026Ontario attic rebate: get up to $1,250 back, no energy audit needed. Serving Toronto & the GTA · (647) 250-0606

Attic Mold Removal & Sanitation

Updated November 9, 2026 · By the Pro Home Insulation team

Quick answer: Attic mould grows when warm, moist air from your home reaches the cold roof deck and condenses. The usual causes are bathroom fans venting into the attic, air leaks through the ceiling, and poor ventilation. Lasting attic mold removal means fixing the cause first, then removing damaged insulation, cleaning and treating the wood, and re-insulating. The new insulation may qualify for Ontario’s attic rebate of up to $1,250. Amounts can change.

Updated November 2026

On this page
  1. 6 common causes of attic mould
  2. How to check your attic for mould
  3. How re-insulating ties into the attic rebate
  4. Moisture and air leakage facts
  5. Cleanup only vs fixing the cause
  6. Our attic mould removal process
  7. Attic mould checklist
  8. example project
  9. Framework: will the mould come back?
  10. Frequently asked questions
  11. Get a free attic assessment

Pro Home Insulation cleans up attic mould across Toronto and the GTA, but cleaning is only half the job. If the moisture source stays, the mould comes back. Our focus is on stopping the moisture, then restoring the attic.

6 common causes of attic mould

  1. Bathroom fans venting into the attic. Fans that dump steam into the attic, or ducts that have come loose, put moisture right on the roof deck.
  2. Air leaks through the ceiling. Warm, moist air rises through gaps at pot lights, pipes, wires and top plates.
  3. Blocked soffit vents. Insulation pushed into the eaves blocks the outside air that should flow under the roof.
  4. Too little roof ventilation. Without enough airflow, moisture has nowhere to go.
  5. Roof leaks. Damaged shingles, flashing or vents let water in directly.
  6. Kitchen or dryer vents ending in the attic. These should always vent outdoors.

How to check your attic for mould

  • Look at the underside of the roof boards. Black, grey or white patches, especially near the eaves and on the north side, are common signs.
  • Check after a cold snap. Frost on nails or boards in winter means moist air is reaching the attic.
  • Follow the bathroom fan duct. Make sure it is connected and runs to a vent outside, not into the attic.
  • Smell for mustiness. A damp, musty odour at the hatch is a warning sign.
  • Avoid disturbing it. Wear a mask and do not scrub or scrape mould yourself in a closed attic.

If the insulation is also damaged, read about attic insulation removal.

How re-insulating ties into the attic rebate

After mould is cleaned up, the attic gets new insulation. That insulation can qualify for the standalone attic path of the Home Renovation Savings Program, which pays 50% of the after-tax insulation cost up to the tier maximum. The mould cleanup itself is a separate cost.

Attic before upgrade Upgrade to at least Maximum rebate
R-12 or less R-50 up to $1,250
Above R-12 to R-25 R-50 up to $1,000
Above R-25 to R-35 R-50 up to $800

See the attic insulation rebate in Ontario for full details, or browse all current rebates.

Moisture and air leakage facts

  • One small air leak can let in 100 times more moisture than diffusion through the same area (Natural Resources Canada).
  • Air leakage is about 20–30% of the heat lost from an older home (Natural Resources Canada).
  • Nearly 1.2 million Ontario residential properties were built in 1960 or earlier (Statistics Canada), and older homes often have more ceiling air leaks.
  • New Ontario homes target about R-60 in the attic (Ontario Building Code SB-12).

Our guide to the signs your attic needs insulation explains how thin insulation and air leaks show up in winter.

Cleanup only vs fixing the cause

Cleanup only Fix the cause plus cleanup
Removes visible mould Yes Yes
Stops new moisture No Yes
Fans vented outside Not checked Yes
Air leaks sealed No Yes
Soffit vents cleared and baffled No Yes
Likely to come back Often Much less likely

Our attic mould removal process

  1. Inspection. We map where the mould is, check the roof deck, fans, ducts and ventilation, and find the moisture source.
  2. Fix the cause. Bathroom fan ducts are reconnected and routed outside, and blocked vents are cleared. Roof leaks are repaired by a roofer.
  3. Contain the area. We protect the hatch and living space below.
  4. Remove damaged insulation. Mouldy or wet insulation is vacuumed out and bagged.
  5. Clean the wood. The roof deck and framing are cleaned with HEPA vacuums and scrubbing as needed.
  6. Treat surfaces. Affected wood is treated with an antimicrobial product, and a sealant may be applied where suitable.
  7. Air seal the attic floor. We seal the leaks that let moist air in. See attic air sealing.
  8. Re-insulate. Baffles go in, then new insulation to R-50 or R-60. See attic insulation.

Attic mould checklist

  • Find where the mould is (eaves, north side, around fans)
  • Confirm bathroom, kitchen and dryer vents go outside
  • Check soffit vents are open and baffled
  • Have any roof leaks repaired
  • Remove wet or mouldy insulation
  • Clean and treat affected wood
  • Air seal the attic floor before re-insulating
  • Recheck the attic after the first cold snap

example project

example — not a specific customer.

A 1980s two-storey home in Brampton has mould on the north side of the roof deck. The bathroom fan duct had come loose and was blowing into the attic. The insulation near the fan is wet; the rest is about R-20.

  • Fix: fan duct reconnected and routed to an outside vent; soffits cleared and baffled.
  • Cleanup: wet insulation removed, roof deck cleaned and treated.
  • Air sealing and re-insulation: attic sealed, then topped up to R-60.
  • Assumed after-tax insulation cost (for illustration, not a quote): $2,200. 50% is $2,200 × 0.5 = $1,100.
  • Rebate: starting level above R-12 to R-25, tier maximum up to $1,000, so up to $1,000.
  • Mould cleanup: a separate cost not covered by the rebate.

Framework: will the mould come back?

Question Yes No
Do all fans vent outside? Good Fix before cleanup
Are ceiling air leaks sealed? Good Seal before re-insulating
Are soffit vents open with baffles? Good Clear and baffle them
Is the roof watertight? Good Repair first
Has the attic been checked after a cold spell? Good Plan a follow-up look

Frequently asked questions

What causes mould in the attic?

Most attic mould comes from moisture inside the home, not rain. Warm, damp air from bathrooms and living spaces leaks into the attic, hits the cold roof deck in winter and condenses. Poor ventilation makes it worse.

Can I just paint over attic mould?

Painting or spraying alone does not fix the moisture problem. Without fixing the cause, mould usually returns. Cleaning, treating and sealing works best when the moisture source is gone.

Is attic mould dangerous?

Mould in any part of a home is worth dealing with, and it is best not to disturb it without protection. If you have health concerns, talk to your doctor. Our job is to remove the mould safely and stop the moisture that feeds it.

Does insurance cover attic mould?

It depends on your policy and the cause. Sudden events like a roof leak may be treated differently than long-term condensation. Check with your insurer before work starts.

Does the attic rebate cover mould removal?

Plan on the rebate covering the new insulation only. On the standalone attic path, it is 50% of the after-tax insulation cost, up to the tier maximum. Check the current rebates, since amounts can change.

Why does attic mould show up mostly in winter?

In cold weather, the roof deck is the coldest surface in the attic. When warm, damp air leaks up from the house, its moisture condenses on those cold boards as water or frost. When the frost melts, the wood stays damp long enough for mould to grow.

Will a new bathroom fan fix my attic mould?

A fan only helps if its duct is sealed and runs all the way to an outside vent. A strong fan blowing into the attic makes the problem worse. We check the full duct run as part of every mould assessment.

How long does attic mould removal take?

Many attics take one to two days, including removal of damaged insulation, cleaning and treatment. Re-insulating may follow right after, once the cause is fixed.

Get a free attic assessment

Pro Home Insulation has more than 10 years of experience restoring attics in Toronto, Brampton, Mississauga and Vaughan. We will find the moisture source and give you a clear plan. Call (647) 250-0606 or Book online.

Find out what your attic needs, and what you get back

Free attic assessment and written quote, with your rebate already worked out.

Call now Free assessment